free freight for any orders over $400 in australia

610cc 60lb Siemens Fuel Injectors x 6 Ford EA - EL, BA BF


Set of 6 x 610cc injectors to suit Ford 6 cylinder from EA to EL and BA BF including turbo. They are direct fit so nothing else is needed.


These high impedance injectors flow 60 lbs/hr at 43.5 PSI ( 3 BAR ). Despite the high flow rate, they are linear and controllable at low pulse widths. This allows you to use a larger injector than normally possible without hurting idle and low speed driveability.

Being high-impedance makes them compatible with most ECUs.

These injectors are able to function at high fuel pressures and don’t exhibit the high fuel pressure handling problems which makes this makes these injectors very well suited to turbocharged and supercharged applications that see high fuel system pressures.

Engine performance and running quality are enhanced through the optimized spray pattern. They utilise a multi-orifice tip providing a true 26 degree spray pattern for improved mixture preparation. This results in lower BSFC and better idle quality than many injectors with less flow. 

They come with an EV1 connector which makes them perfect for older style Falcons and Commodores without making any modifications. You may also need to upgrade your fuel pump if you are fitting these. Have a look at the related items for the best options.

Coil Resistance: 12.5 Ohms / High Impedance / High-Z (No ECM driver modifications required)
Static Flow Rate @ 43.5PSI ( 300kPa ) w/Petrol: 60 lb/hr = 630 cc/min = 453 g/min
Static Flow Rate @ 87PSI ( 600kPa ) w/Petrol: 85.7 lb/hr = 900 cc/min = 648 g/min
Gain: 0.11ms/mg
Offset: 0.055ms
Turn on time @ 14VDC: 1.14ms
Turn off time: 0.85ms @ 600KPa
Connector: Bosch EV1
Series: DEKA 4 ( DEKA IV )
Orifice Type: Multi-orifice
Spray Pattern: 30 Degree Spray Cone
Factory fitted with Viton upper and lower o-rings

Equivalent Part Numbers:
Siemens FI114961, 107-961, 107961

  • Internal Part Number:   HP610CHx6Ford
  • Brand:   Siemens VDO
  • CC Rating:   610cc
  • Ohms (Resistance):   High
  • Length (o-ring to o-ring):   65mm - Full Length
  • Top O-Ring Diameter:   14mm